Garage

Throttle and clutch cables: lubrication and adjustment

A stiff cable or no free play ruins control, and in cold, wet weather a damp cable can even seize. November is a good time to check both.

  • Switch the ignition off, turn the bars through their full range and check that the throttle doesn't change idle and snaps back on its own.
  • Release the throttle and check free play: on most bikes it is a few millimetres of slack before the cable starts to move. Find the exact figure in the owner's manual.
  • Inspect the housings for cracks, kinks, rubbed spots and frayed ends. Any of these means replacement.
  • Disconnect the cable from the lever or drum, lubricate it with a dedicated cable lubricant or drip it down the housing and let it drain. Then lubricate the lever pivot and the nipple.
  • Set free play with the adjuster at the lever or mid-cable, tighten the locknut and recheck the action with the bars at both extremes.
  • A sticking throttle or problems with carburettor or throttle body linkage are best left to a workshop, since handling depends on them.

This post was prepared with AI assistance.

Download BRAP

Discuss the news with other riders, record your rides and find people to ride with. Free on iOS and Android.

Read next

← Back to Pitstop