- Home
- BRAP Pitstop
- Motorcycle won't start: step-by-step diagnosis
Garage
Motorcycle won't start: step-by-step diagnosis
In November, a bike that ran fine yesterday can refuse to fire after a cold night. Work from the simple to the complex instead of swapping parts at random.
- Check the obvious: kill switch in the run position, ignition on, sidestand up, and on bikes with the relevant interlock, clutch pulled in or neutral selected.
- Check fuel: is there petrol in the tank, and is the fuel tap open if the bike has one. Switch the ignition on and listen for the fuel pump hum.
- Judge the starter. If it cranks sluggishly and the dash dims or dies, suspect the battery or poor terminal contact. If you only hear a click from the relay, start with the battery too.
- Remove the terminals and inspect them: clean off corrosion and tighten firmly. Measure battery voltage: about 12.6 V at rest, and below 12 V means deep discharge.
- If the starter spins briskly but the engine won't catch, check the spark plugs: they should be dry and clean. Plugs flooded with fuel should be dried or replaced.
- Don't crank continuously: 5 seconds at most, then wait a minute, or you'll drain the battery and overheat the starter. If you suspect the fuel system or wiring, go to a workshop.
This post was prepared with AI assistance.
Download BRAP
Discuss the news with other riders, record your rides and find people to ride with. Free on iOS and Android.
Read next
Garage