- Home
- BRAP Pitstop
- Compression test: how it's done and why it matters
Garage
Compression test: how it's done and why it matters
A compression gauge shows whether a cylinder holds pressure, which is the quickest check of the rings, valves and head gasket. November suits it: the bike is parked anyway, and it's better to find a problem now than in a spring rush.
- Warm the engine to operating temperature, shut it off and pull the spark plugs. The engine should be warm, not hot.
- Disable the ignition and fuel supply as your owner's manual describes, so you don't flood the cylinders or damage the coils.
- Thread the gauge into the plug hole straight, without cross-threading, and tighten it snugly by hand.
- Open the throttle fully and crank the engine with the starter for a few seconds until the needle stops climbing.
- Write down the reading, release the pressure and repeat for every cylinder. Compare with the manual's spec: cylinders shouldn't differ noticeably.
- If a reading is low, add a little clean engine oil to that cylinder and test again: if it rises, the rings are at fault; if not, suspect the valves.
This post was prepared with AI assistance.
Download BRAP
Discuss the news with other riders, record your rides and find people to ride with. Free on iOS and Android.
Read next
Garage